How To: Install and Set Up Your Commercial Sink
I just received my Transplumb Commercial Sink...what now!?
Thanks for your order! Our Commercial Sink self-contained hand washing station has been designed for easy set up and installation - anyone can do it! Included with every purchase is an easy to follow owner's set up and user manual which looks a little bit like the steps you see below. Also included with every purchase is 2 packs of disinfection tablets, so you can maintain your unit consistently!
To begin, remove all items from the box, see below.
Description of Contents
1. Water Reservoir 2. Mounting Screws ( x 6 )
3. Foam Insert 4. Motion Sensor
5. Tap 6. Main Body
What next?
The Commercial Sink is designed to be mounted to any wall, bench or suitable backing. To mount the unit, it is recommended that you place the main body on top of foam packaging insert to achieve a suitable height for the basin (recommended height from floor to basin is 80-100cm).
Installation
- Ensure body is flush against wall.
- Mark the mounting holes on the wall to pre-drill (2 x splashback, 4 x body).
- Drill holes.
- Insert appropriate screw fixings (as required).
- Insert screws into the wall/backing and fix securely.
Now what?
Now your unit is securely mounted, you are now ready to setup and start using your hand washing station.
Set Up
To Fill:
- Disconnect the fresh water hose from the white cap and remove the waste hose from red cap.
- Remove water tank from unit.
- Unscrew white cap and fill with fresh tap water at ambient temp.
- Re-attach the white cap and re-connect the fresh and waste hose.
To Empty:
- Disconnect the fresh water hose from the white cap and remove the waste hose from red cap.
- Remove the water tank from unit.
- Empty waste water out of reservoir into appropriate sink or toilet.
- IMPORTANT: Ensure to rinse/flush the sink or toilet to ensure all waste water is removed.
- Repeat 'To Fill' procedure.
Wash Cycle Operation
- First, plug the unit in to power (normal 10amp, 220/240v household power point).
- To begin, turn on, allow the unit to purge, then place hands in the bowl for detection by the sensor.
- Once detected, the sensor light will flash for 3-5 seconds while water is heating.
- A hot water rinse (40/45 deg) will then run for 10 seconds.
- Remove hands from bowl briefly to reset sensor, once hands are temporarily removed, the sensor will reset.
- Once sensor light is lit again, the unit is ready for another wash cycle.
Installation Complete
You have successfully installed your Commercial Sink. Please refer to the Manual provided for instruction on upkeep and cleaning maintenance of your unit - or give us a call! 1300 537 300 (AUS) or +61 3 8353 7310 (International).
Alternatively, contact us here for more info on our range of portable and self-contained sinks.